EternaBond - Repairing a rubber roof front cap seam on a Recreational Vehicle

Installation Instructions

Easy to Install - Permanent Results!

Repairing a rubber roof front cap seam on a Recreational Vehicle using WebSeal and EternaShield Tintable Roof Coating
(Recommendation: review the above installation instructions for repairing a roof tear first.)

Shown, a typical factory roof seam...

Gently clean the surface.
Cut EternaBond to length.

Place EternaBond tape right over the original seal.

EternaBond will not adhere to silicone. All silicone and silicone residue that runs along the edge of the EternaBond must be removed.

Cover the entire seal. Smooth down the EternaBond tape with your hand, applying pressure as you rub.

Apply 2 Coats of EternaBond UV Protector (if required)... Better than New!
This repair took less than 20 minutes and the RV was ready to drive! NO WAITING!

An entire roof reseaming can take as little as 2 hours, and it's permanent!

Installation Instructions

Repairing a rubber roof front cap seam on a Recreational Vehicle using WebSeal and EternaShield Tintable Roof Coating (Recommendation: review the above installation instructions for repairing a roof tear first.)

Repairing a rubber roof front cap seam on a Recreational Vehicle using WebSeal and EternaShield Tintable Roof Coating
(Recommendation: review the above installation instructions for repairing a roof tear first.)