EternaBond - Repairing a tear on the rubber roof of a Recreational Vehicle

Repairing a tear on the rubber roof of a Recreational Vehicle using WebSeal and EternaShield Tintable Roof Coating

Everything you need...

EternaBond Leak Repair Tape
EternaBond Tintable UV Protector and brush
Scissors
Cloth

Clean the area to be repaired... the cleaner and drier the better.
(EternaBond tapes will usually aggressively bond to non-cleaned surfaces, however, we suggest using soap and water, or a gentle cleaning agent like "final wash" or rubbing alcohol, or just briskly rubbing the area with a dry towel.)

Cut tape to length required.

Remove the release liner.

Start the repair by placing one end of the tape to the surface.

Finish putting tape over repair area.
EternaBond is pressure sensitive tape. Minimal stretching of the tape is recommended.

Paint on 2 Coats of EternaBond UV Protector... You're Done!
A permanent repair in less than 10 minutes. You're ready to go!
NO WAITING!

(Note: EternaBond Tintable UV Protector is only required when using WB-Seal on areas exposed to sunlight. All other EternaBond leak repair products are UV protected and require no other protection. UV Protector can be tinted to match most surface colors. This step can be performed at a future time.)>

Installation Instructions

Repairing a tear on the rubber roof of a Recreational Vehicle using WebSeal and EternaShield Tintable Roof Coating